How To Remove A Stuck Nail

How To Remove A Stuck Nail

If you are like most people, you have probably tried to remove a stuck nail a few times before. Most of the time, this involves trying to pry it out with a blunt object, which usually doesn’t work. If you have tried everything and the nail still won’t come out, there is one last resort.

How To Remove A Stuck Nail – DIY At Bunnings

Removing a stuck nail is a common problem for both novice and experienced nail technicians. There are a few different techniques that can be used to remove a stuck nail, but the most common is to make use of a pneumatic naildriver.

To use a pneumatic naildriver, you will need to gather the following items:

  • Nail gun
  • Pneumatic naildriver
  • Workbench
  • Hammer
  • Anvil
  • Chisel
  • Screwdriver

    To use the pneumatic naildriver, first make sure the workbench is level and secure. Next, place the anvil on the workbench, so that the hammer is hanging over the top. Place the nail gun on the anvil so that the nail is pointing down. Place the nail into the gun, and press the trigger to fire the nail. The nail will travel through the air and hit the naildriver, which will then drive the nail out of the wood. Be sure to use a slow speed when using the pneumatic naildriver, as too much speed can cause the nail to break.

The Tools You’ll Need

There are a few different tools that you will need in order to remove a stuck nail.

The first thing that you will need is a pair of pliers. You will also need a hammer and a nail.

To remove a stuck nail, you will first need to loosen it up using the pliers. This can be done by gripping the pliers around the top of the nail and slowly twisting them until the nail begins to move.

Once the nail has started to move, you can use the hammer to hit it on the side, which will break the nail free. If the nail is particularly stubborn, you may need to use the pliers and hammer together to break it free.

Once the nail is free, you can remove it from the wall. Be careful not to hit your fingers with the hammer or pliers!

Preparing The Nail

  1. Clean the area around the nail with a disinfectant soap and water mixture, if necessary.

    2. Apply a thick layer of nail varnish to the nail.

    3. Place a thin, flathead screwdriver or other thin, sharp object on the top of the nail and drive it down until it lodges in the varnish.

    4. Apply pressure with your other hand to the screwdriver and twist it in a twisting motion.

    5. Continue twisting the screwdriver while trying to pull it out. If the screwdriver pops out easily, the nail is loose and can be removed. If it doesn’t pop out easily, continue twisting the screwdriver and pull out the entire nail.

    6. If the screwdriver doesn’t pop out easily, use a pair of pliers to remove the nail.

Loosening The Nail

Removing A Stuck Nail:
Carefully grip the end of the nail, approximately one-half inch from the end. Twist the nail counterclockwise as you pull (Figure 1). Be careful not to pull the nail out of the wood. If the nail does pull out, use a new tool to remove the other half of the nail.
Figure 1:
Using a tool to twist the nail out of the wood.

If the nail does not budge, use a prying tool to gently push on the end of the nail from either side of the wood (Figure 2). The nail should start to come loose. If it does not, repeat steps 1-3.
Figure 2:
Prying the nail loose from the wood.

If the nail still does not come loose, use a screwdriver or nail puller to remove the nail (Figure 3). Be sure to use a blunt object to avoid damaging the surrounding wood.
Figure 3:
Removing the nail with a screwdriver or nail puller.

Pulling The Nail

If your nail is stuck in the nail bed, gently pushing on the nail with a finger will not dislodge it. If the nail is embedded in the nail bed, your only recourse may be to use a pincer or pliers to pull the nail out.

If the nail is only partially embedded, it may be possible to use a pincer or pliers to grip the nail at one end and use a twisting motion to pull it out. Be very careful not to gouge the nail bed. If the nail is embedded deeply in the nail bed, it is not possible to remove it without damaging it.

Finishing Up

First, start by locating the nail that is stuck. Often times this will be the middle or bottom nail on the finger. Using a finger groove technique, gently pry up on the nail until it pops free. If the nail is too hard to remove, you can try using a nail file. Be gentle and file only in one direction. If the nail still doesn’t come free, you may need to use a nail glue or a nail stripper.

Be careful not to cut your finger while removing the nail. Once the nail is free, clean the area and dry it off. Apply a light coat of polish and you’re done!

Conclusion

If you have a nail that is stuck in the nail polish or nail varnish, you can use a few simple techniques to remove it. First, try to remove the nail by breaking it off at the base. If that doesn’t work, try using a nail pry bar. If that still doesn’t work, you can use a file to remove the nail.

See also  How To Get Nail Polish Without Nail Polish Remover

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *